I am currently in the process of designing a node that will control small servo motors (in groups of three) that I have attached to 14 plantation shutters in my house. This will allow me to open, close, and set the shutters to almost any position on an individual basis. I plan to have them open/close based on the time of day, occupancy in the house, season and sunlight direction, outside temperature and inside cooling/heating set points, and privacy times based on if the shower is/was in use and/or bath tub was/is in use.

I finally got around to adding some new pages and updating some old ones. Just added a page on my Lighting and Devices, RS485 Network and Multi-Purpose Node. Also updated information about the wiring closet and main controller.